What this service covers
Built for how Louisiana homes are actually constructed: raised piers, vented crawlspaces, slabs poured close to grade, and additions that sit lower than the original house.
Vented crawlspaces
Standing water after heavy rain, leaking supply or drain lines, and saturated soil that keeps joists and subfloor damp for weeks. Crews pump water out, pull ruined insulation, rinse silt where needed, and run commercial dehumidification with directed airflow until wood moisture readings stabilize.
Raised homes and pier cavities
Older Acadian cottages, shotgun doubles, and elevated new builds trap humid air between piers. Providers check enclosed skirting, under-floor ductwork, and plumbing penetrations, then dry the cavity and advise on vapor barrier repair and vent management for Gulf humidity.
Slab edges and low additions
Many slab homes sit only inches above grade, so poor grading or clogged gutters push water straight to the slab edge and wick it under flooring. Techs map the migration with meters, lift affected flooring sections, and dry the slab before new material goes down.
Garage conversions and utility rooms
Converted garages and low laundry rooms flood first because their floors were never raised to living-space height. Crews extract, remove unsalvageable drywall at the base, dry wall cavities, and document everything for repair crews and adjusters.
Warning signs of low-area water damage
Crawlspace moisture hides. These clues mean water is sitting or cycling where you cannot see it.
Musty or earthy odors
A sour or soil-like smell near floor vents, closets, or the access hatch often means damp soil or wet insulation below. In Louisiana humidity, mold can begin growing within 24 to 48 hours.
Buckling or cupping floors
Vinyl plank lifting at seams, hardwood cupping, or tile grout darkening along one wall points to moisture wicking up from below or pressing in at the slab edge.
Sagging insulation and drips
If batt insulation hangs down at the access door or you see water beading on ductwork, humid air plus a leak or seepage is soaking the cavity. Do not crawl in standing water to check.
Doors and trim swelling
Interior doors that suddenly stick, baseboards that swell, and paint bubbling near the floor line all signal prolonged low-level moisture rather than a one-time spill.
High indoor humidity
A home that never drops below 60 percent relative humidity despite the air conditioner running may be pulling moisture straight from a wet crawlspace into the living area.
Water at the access door
Visible puddles, mud lines on piers, or silt piled near vents after storms confirm intrusion. Photograph it from outside and call before it soaks the subfloor.
Our drying process
Pump first, then dry to the number — not the calendar.
1. Safety check and source ID
Techs confirm electrical safety, identify whether the water is clean supply water, gray water, or stormwater, and photograph levels and mud lines before anything is moved.
2. Pump-out and extraction
Standing water is pumped or extracted from the crawlspace, slab edge channels, or converted floor. Wet debris, silt, and ruined insulation are bagged and removed so airflow can reach wood and soil.
3. Moisture mapping
Meters and probes record wood moisture content, slab readings, and indoor humidity room by room. Those baseline numbers set equipment placement and prove progress to your insurer.
4. Directed drying
Commercial dehumidifiers, air movers, and sometimes focused under-floor airflow run for several days. Crews return to recheck readings, reposition equipment, and reset vapor barriers that were disturbed.
5. Prevention handoff
You get the drying log, photos, and practical next steps: grading and gutter fixes, skirting and vent guidance, and when to schedule a mold check if materials stayed wet past 48 hours.
When to call immediately
Call (888) 217-5329 right away if standing water is visible under the house, a supply line or water heater has burst over a low floor, sewage or a septic odor backs up through low drains, stormwater entered through vents or skirting, or breakers trip when the air handler runs. Stay out of standing water, avoid the crawlspace entry, and shut the supply valve only if you can reach it safely and dryly.
Water Under the House? Call Now.
Live answer 24/7 — a local crew can pump and start drying today.
Common Questions
My Louisiana home has no basement. Do I still need this service?
Likely yes if you have a vented crawlspace, a raised pier home, or a slab addition that stays damp. Most Louisiana calls are for crawlspaces and low floor cavities, not full basements.
How do I know my crawlspace is wet?
Musty odors, buckling vinyl plank, damp insulation hanging down, standing water at the access door, and stubbornly high indoor humidity are common clues. A moisture meter reading confirms it.
How long does crawlspace drying take?
Most jobs need 3 to 6 days of active drying after pump-out, depending on soil saturation, insulation condition, and outdoor humidity. Daily readings decide when equipment comes out.
Will my homeowners insurance cover crawlspace water?
Sudden plumbing failures are often covered; groundwater seepage and rising floodwater usually require separate flood insurance. Providers document the source, affected areas, and drying record for your claim.
Serving communities statewide
Participating providers cover these cities and surrounding parishes: